CVE index

In the Linux kernel, the following vulnerability has been resolved: thunderbolt: Clamp XDomain response data copy to allocation size tb_xdp_properties_request() derives the per-packet copy length from the response header without checking that it fits in the previously allocated data buffer. A malicious peer can set its length field larger than the declared data_length, causing memcpy to write past the kcalloc allocation. Clamp the per-packet copy length so that the cumulative offset never exceeds data_len.

In the Linux kernel, the following vulnerability has been resolved: thunderbolt: Validate XDomain request packet size before type cast tb_xdp_handle_request() casts the received packet buffer to protocol-specific structs without verifying that the allocation is large enough for the target type. A peer can send a minimal XDomain packet that passes the generic header length check but is shorter than the struct accessed after the cast, causing out-of- bounds reads from the kmemdup allocation. Plumb the packet length through xdomain_request_work and validate it against the expected struct size...

In the Linux kernel, the following vulnerability has been resolved: thunderbolt: Limit XDomain response copy to actual frame size tb_xdomain_copy() copies req->response_size bytes from the received packet buffer regardless of the actual frame size. When a short response arrives, this reads past the valid frame data in the DMA pool buffer into stale contents from previous transactions. Use the minimum of frame size and expected response size for the copy length.

In the Linux kernel, the following vulnerability has been resolved: drm/gem: Try to fix change_handle ioctl, attempt 4 [airlied: just added some comments on how to reenable] On-list because the cat is out of the bag and we're clearly not good enough to figure this out in private. The story thus far: 5e28b7b94408 ("drm: Set old handle to NULL before prime swap in change_handle") tried to fix a race condition between the gem_close and gem_change_handle ioctls, but got a few things wrong: - There's a confusion with the local variable handle, which is actually the new handle, and so the two-sta...

In the Linux kernel, the following vulnerability has been resolved: drm/amdkfd: Fix buffer overflow in SDMA queue checkpoint/restore on GFX11 The v11 MQD manager incorrectly assigned the CP-compute variants of checkpoint_mqd/restore_mqd for KFD_MQD_TYPE_SDMA queues. These functions use sizeof(struct v11_compute_mqd) (2048 bytes) instead of sizeof(struct v11_sdma_mqd) (512 bytes), causing a 1536-byte overflow. During CRIU checkpoint of an SDMA queue on Navi3x: - checkpoint_mqd() reads 2048 bytes from a 512-byte SDMA MQD buffer, leaking 1536 bytes of adjacent GTT memory to userspace During CR...

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Bound VBIOS record-chain walk loops [Why & How] All record-chain walk loops in bios_parser.c and bios_parser2.c use for(;;) and only terminate on a 0xFF record_type sentinel or zero record_size. A malformed VBIOS image missing the terminator record causes unbounded iteration at probe time, potentially hundreds of thousands of iterations with record_size=1. In the final iterations near the BIOS image boundary, struct casts beyond the 2-byte header validated by GET_IMAGE can also read out of bounds. Cap all 1...

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Clamp HDMI HDCP2 rx_id_list read to buffer size [Why & How] During HDCP 2.x repeater authentication over HDMI, the driver reads the sink's RxStatus register and extracts a 10-bit message size field (max value 1023). This value is used as the read length for the ReceiverID list without being clamped to the size of the destination buffer rx_id_list[177]. A malicious HDMI repeater could advertise a message size larger than the buffer, causing an out-of-bounds write during the I2C read. Clamp the read length in...

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Clamp VBIOS HDMI retimer register count to array size [Why & How] The VBIOS integrated info tables (v1_11 and v2_1) contain HdmiRegNum and Hdmi6GRegNum fields that are used as loop bounds when copying retimer I2C register settings into fixed-size arrays (dp*_ext_hdmi_reg_settings[9] and dp*_ext_hdmi_6g_reg_settings[3]). These u8 fields are not validated before use, so a malformed VBIOS can specify values up to 255, causing an out-of-bounds heap write during driver probe. Clamp each register count to the des...

In the Linux kernel, the following vulnerability has been resolved: RDMA/umem: Fix truncation for block sizes >= 4G When the iommu is used the linearization of the mapping can give a single block that is very large split across multiple SG entries. When __rdma_block_iter_next() reassembles the split SG entries it is overflowing the 32 bit stack values and computed the wrong DMA addresses for blocks after the truncation. Use the right types to hold DMA addresses.

In the Linux kernel, the following vulnerability has been resolved: vsock/virtio: fix potential unbounded skb queue virtio_transport_inc_rx_pkt() checks vvs->rx_bytes + len > vvs->buf_alloc. virtio_transport_recv_enqueue() skips coalescing for packets with VIRTIO_VSOCK_SEQ_EOM. If fed with packets with len == 0 and VIRTIO_VSOCK_SEQ_EOM, a very large number of packets can be queued because vvs->rx_bytes stays at 0. Fix this by estimating the skb metadata size: (Number of skbs in the queue) * SKB_TRUESIZE(0)

In the Linux kernel, the following vulnerability has been resolved: netfilter: require Ethernet MAC header before using eth_hdr() `ip6t_eui64`, `xt_mac`, the `bitmap:ip,mac`, `hash:ip,mac`, and `hash:mac` ipset types, and `nf_log_syslog` access `eth_hdr(skb)` after either assuming that the skb is associated with an Ethernet device or checking only that the `ETH_HLEN` bytes at `skb_mac_header(skb)` lie between `skb->head` and `skb->data`. Make these paths first verify that the skb is associated with an Ethernet device, that the MAC header was set, and that it spans at least a full Ethernet h...

Redis Lua HEAP overflow in cjson library vulnerability in Apache Kvrocks. This issue affects Apache Kvrocks: from 2.0.4 through 2.15.0. Users are recommended to upgrade to version 2.16.0, which fixes the issue.

Improper Handling of Insufficient Permissions or Privileges vulnerability in Apache Kvrocks. This issue affects Apache Kvrocks: 2.8.0. Users are recommended to upgrade to version 2.16.0, which fixes the issue.

The Tourfic – AI Powered Travel Booking, Hotel Booking & Car Rental WordPress Plugin plugin for WordPress is vulnerable to generic SQL Injection via the 'post_id' parameter in all versions up to, and including, 2.22.7 due to insufficient escaping on the user supplied parameter and lack of sufficient preparation on the existing SQL query. This makes it possible for unauthenticated attackers to append additional SQL queries into already existing queries that can be used to extract sensitive information from the database. The AJAX handler is registered for unauthenticated users via wp_ajax_nop...

The InPost PL WordPress plugin before 1.9.1 does not verify that the request originates from the legitimate buyer before allowing the WooCommerce order parcel-locker destination to be updated, allowing unauthenticated attackers to silently redirect the shipping destination of any pending or processing order on the site.